Cp input set, Input set, Output set – Grass Valley VM 3000 System Controllers v.7.4 User Manual
Page 268: Override set, Sequence set, Category set, Mpk devices

Configurator
CP Input Set
5−58
VM 3000 Installation and Operating Manual
CP Input Set
Figure 5−40. CP Input Set (example showing new Auto Mnemonic column).
1
Input Set — KXYZ−INP
Category
Entry
Mnemonic
Logical
2
3
Test
1
BARS
BARS
VTR
1
VT01
VT01
4
5
Test
2
TONE
TONE
Test
3
CODE
TC
VTR
2
VT02
VT02
VTR
3
VT03
VT03
VTR
4
VT04
VT04
VTR
5
VT05
VT05
MISC
8
ESS
ESS
6
7
8
n
Auto
Mnem
Input
Control Panel Sets
Level set
Machines
TCS−1 Device Codes
Status Display Header
Tally
Exclusion
The CP Input Sets are used to link particular category / entry numbers, and mnemonics, to switcher input names. CP Input
Sets are also used to assign an input to each source button on CP 3832 and CP 3864 Control Panels.
S Categories are classes of inputs/outputs. The factory default category sets (as shown on pages 5−64 and 5−65) can
be used; or, custom category sets can be created.
Example: “TEST” as the category for all test signals. The cate-
S An entry number. This defines the unit within the category. To continue the above example, after pressing “TEST,”
the operator presses the “1” key to switch to the color bar input. Note that the entry number is not the same as the
switcher input/output number.
S A mnemonic is an abbreviation, usually with a length of four characters, for a particular switcher input or output.
This is the abbreviation that appears in the status windows of the control panels. Example: “VT01” as a display
mnemonic for switcher input 001.
†
If you want to create a custom category set, skip to CP Category Set (page 5−103) and then return to this subsection.