Grass Valley VM 3000 System Controllers v.7.4 - Manual (Page 346)

Configurator MPK Devices
5−136 VM 3000 Installation and Operating Manual
CP 3810 APPLICATIONS
The optional CP 3810 panel can be associated with a CP 3832, CP 3864, CP 3808, or CP 3830, providing control of up to
80 output buses. The CP 3810 can also be assigned to one output, providing breakaway (split) switching and/or multi−level
status.
Multi−Bus Control
In the example shown in Figure 5−116, a CP 3832 is being used to select 32 inputs while the CP 3810 is used to select 80
outputs.
MPK bus
VM 3000
“VM1”
CP 3832
“CP3832”
CP 3810
“CP3810”
32
sources
80 destinations
(8 windows X 10 pages)
Figure 5−116.
CP3832 CP−3832 2 00000043 3832−IN 3832−OUT
CP3810 CP−3810 2 00000044
1
MPK Devices
MPK
Expansion
Pass
Board
VM1
Port Address Input Sets Output Sets Level Set Overide Set Sequence Set
2 VM1
KXYZ−LEV
Devices word In Panel Out Panel
Figure 5−117. Entry for system shown in Figure 5−114.
CP3832
Device
Type
Notice that the Expansion boxes for both panels are unchecked.
Main panel entries — In this example, a CP 3832 is the “main” panel and is therefore assigned specific CP sets. In the “Input
Set” column, enter the name of the CP Input Set that will be used to assign inputs to the main panel (for more information
about CP Input Sets, see page 5−58). In the “Output Set” column, enter the name of the CP Output Set that will be used to
assign outputs to the CP 3810 (for more information about CP Output Sets, see page 5−76).
Note: Even when associated with a CP 3810, the main panel is still configured independently and can be operated
independently. In this example, the CP 3832 will operate as a single−bus control panel (because Expansion = No).
The CP 3832 will be assigned to the first output listed in CP Output Set “3832−OUT.”
CP 3810 entries — In the “In Panel” column, enter the name of the main panel. CP 3810S (“sticky outputs”) entries are similar
to the CP 3810, except the Device Type is “CP−3810S.”
For operating instructions, see page 6−126.