Able” and skip to step 11 – Grass Valley VM 3000 System Controllers v.7.4 User Manual
Page 276

Configurator
CP Input Set
5−66
VM 3000 Installation and Operating Manual
The 16−category factory default set used for CP 320 and CP 328 panels is as follows:
VTR
CG
NET
VCR
CAM
AUX
EJ
SS
REM
FILM
PTCH
STU
TEST
SAT
FS
MISC
The 15−category factory default set used for CP 3824 panel is as follows:
VTR
CG
NET
VCR
CAM
AUX
SS
REM
FILM
PTCH
STU
TEST
SAT
FS
MISC
The 12−category factory default set used for the CP 3830 and CP 3830P panels:
VTR
GFX
Studio
ENG
REM
NET
EC
POST
Xmsn
AUX
TEST
NUM
Guidelines for using the editor are found on page 5−3.
b.
Specify the desired Entry (unit) number. This can be done by double−clicking on the desired “Entry” field and
typing in the number. Press ENTER.
Note: For an input that is heavily used, an entry number of zero can be used to help speed up control
panel operation. For more information, see the note in Step 9 (b) above.
c.
Enter the desired Mnemonic.
A CP 320 panel can display four−character mnemonics; the CP 328, CP 3808, CP 3824, and CP 3830 can display
eight−characters.
d.
Enter the Input name.
The input name will be a name already entered on the Switcher Input table (page 5−44).
11.
MC 3020L Linkage Panel
If you are entering a set for an MC 3020L Linkage Panel, a menu similar to that shown in Figure 5−46 will appear.
1
Input Set — LinkMach
Machine Name
VT01
2
VC01
3
VC02
4
VC03
Figure 5−46. CP Input Set used to establish machine names
for MC 3020L (example). The corresponding system is shown
on page 2−73.