Grass Valley VM 3000 System Controllers v.7.4 - Manual (Page 273)

Configurator CP Input Set
5−63 VM 3000 Installation and Operating Manual
If you want to use a factory default category set (as shown on pages 5−64 and 5−65) leave the Category Set as “Default.”
If you wish to associate an existing Input Set with a different category set than the one originally assigned, see page 5−107.
6. Click on one of the CP types:
cp2002B
cp3000
cp3008
cp3800
cp3808
cp3830
cp320
cp328
cp3310
cpsatrn
†
emem
mc3020L
serial
umd3a
cp3824
cp3832
Figure 5−44.
•
If CP 2002, CP 3000, CP 3008, or CP 3800 is selected, clicking on “Apply” and “Open Table” will open a
blank version of the table shown in Figure 5−45. These are 20−category panels. Go to Step 9.
•
If CP 320, CP 328, or CP 3808 is selected, clicking “Apply” and “Open Table” will open a blank version of
the table shown in Figure 5−45. These are 16−category panels. Go to Step 10.
•
For CP 3030 panels, select type “CP 3000.” Clicking on “Apply” and “Open Table” will open a blank version
of the table shown in Figure 5−45. These are 20−category panels. Go to Step 9.
•
If CP 3824 is selected, clicking on “Apply” and “Open Table” will open a blank version of the table shown in
Figure 5−45. This is a 15−category panel. Go to Step 10.
•
For CP 3830 or CP 3830P panels, select type “CP 3830.” Clicking on “Apply” and “Open Table” will open a
blank version of the table shown in Figure 5−45. This is a 12−category panel. Go to Step 10.
•
If MC 3020L is selected, click on “Apply” and “Open Table” and skip to Step 11.
•
For RP 1/2/3, RP 1/2/3 C, and SlimLine UMD status displays, select type UMD3A.
•
For Diamond DD applications, both “E−MEM” and “serial” tables will probably be required. Clicking on
“Apply” and “Open Table” will open a blank version of the table shown in Figure 5−45. For the E−MEM
table, skip to Step 12. For the serial table, skip to Step 13.
† Not used. Saturn configuration instructions are described in the Saturn Master Control Switcher Installation and Operat-
ing Manual.