Dell PowerEdge VRTX - Manual (Page 778)

778 Quality of Service (QoS) Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\QoS.fm
D E L L C O N F ID E N T IA L – P R E L IM I N A RY 4 / 3 /1 4 - FO R P R O O F O N LY
Example
The following example sets a traffic shaper on gi0/1 when the average traffic
rate exceeds 64 kbps or the normal burst size exceeds 4096 bytes.
console(config)# interface gi0/1
console(config-if)# traffic-shape 64 4096
traffic-shape queue
The egress port shaper controls the traffic transmit rate (Tx rate) on a queue
on a port.
Use the traffic-shape queue Interface Configuration mode command to
configure the egress queue shaper. Use the no form of this command to
disable the shaper.
Syntax
traffic-shape queue queue-id committed-rate [ committed-burst ]
no traffic-shape queue queue-id
Parameters
queue-id—Specifies the queue number to which the shaper is assigned.
(Range: 1-8 ).
• committed-rate—Specifies the average traffic rate (CIR) in kbits per
second (kbps). (Range: 64 kbps–maximum port speed)
• committed-burst—Specifies the excess burst size (CBS) in bytes. (Range:
4096 - 16762902 bytes)
Default Configuration
The shaper is disabled.
Command Mode
Interface (Ethernet) Configuration mode