Dell PowerEdge VRTX - Manual (Page 424)

424 Address Table Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\Address_Table.fm
D E L L C O N F ID E N T IA L – P R E L IM I N A RY 4 / 3 /1 4 - FO R P R O O F O N LY
• ethernet interface-list —Specifies a list of Ethernet ports. Separate
nonconsecutive Ethernet ports with a comma and no spaces. Use a hyphen
to designate a range of ports.
• port-channel port-channel-list —Specifies a list of port channels. Separate
nonconsecutive port-channels with a comma and no spaces. Use a hyphen
to designate a range of port channels.
Default Configuration
No forbidden addresses are defined.
The default option is add.
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
Before defining forbidden ports, the Multicast group should be registered.
You can execute the command before the VLAN is created.
Example
The following example registers an IPv6 Multicast address, and forbids the
IPv6 address on port gi0/4 within VLAN 8.
console(config)# interface vlan 8
console(config-if)# bridge multicast ipv6 ip-address
FF00:0:0:0:4:4:4:1
console(config-if)# bridge multicast ipv6 forbidden ip-
address FF00:0:0:0:4:4:4:1 add gi0/4
bridge multicast ipv6 source group
Use the bridge multicast ipv6 source group IInterface (VLAN) Configuration
mode command to register a source IPv6 address - Multicast IPv6 address pair
to the bridge table, and statically add or remove ports to or from the source-
group. Use the no form of this command to unregister the source-group-pair.