Dell PowerEdge VRTX - Manual (Page 710)

710 IPv6 Tunnel Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\Tunnel New Edition.fm
D E L L C O N F ID E N T IA L – P R E L IM I N A RY 4 / 3 /1 4 - FO R P R O O F O N LY
Default Configuration
The automatic tunnel router's default domain name is ISATAP.
Command Mode
Interface (Tunnel) Configuration mode
User Guidelines
This command determines the string that the host uses for automatic tunnel
router lookup in the IPv4 DNS procedure. By default, the string ISATAP is
used for the corresponding automatic tunnel types.
Only one string can represent the automatic tunnel router name per tunnel.
Using this command, therefore, overwrites the existing entry.
The empty string means that automatic lookup is not applied.
Example
The following example configures the global string ISATAP2 as the automatic
tunnel router domain name.
console(config)# interface tunnel 1
console(config-if)# tunnel isatap router ISATAP2
console(config-if)# exit
tunnel mode ipv6ip
Use the tunnel mode ipv6ip command in Interface Configuration mode to
configure a static IPv6 tunnel interface. To remove an IPv6 tunnel interface,
use the no form of this command.
Syntax
tunnel mode ipv6ip isatap
no tunnel mode ipv6ip
Parameters
• isatap—Specifies IPv6 automatic tunneling mode as ISATAP to connect
IPv6 nodes (hosts and routers) within IPv4 networks.