Bridge multicast ip-address – Dell PowerEdge VRTX User Manual
Page 414

414
Address Table Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\Address_Table.fm
D E L L C O N F ID E N T IA L – P R E L IM I N A RY 4 / 3 /1 4 - FO R P R O O F O N LY
• ethernet
interface-list
—Specifies a list of Ethernet ports. Separate
nonconsecutive Ethernet ports with a comma and no spaces. Use a hyphen
to designate a range of ports.
•
port-channel
port-channel-list
—Specifies a list of port channels. Separate
nonconsecutive port-channels with a comma and no spaces. Use a hyphen
to designate a range of port channels.
Default Configuration
No forbidden addresses are defined.
Default option is add.
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
Before defining forbidden ports, the Multicast group should be registered,
using
.
You can execute the command before the VLAN is created.
Example
The following example forbids MAC address 0100.5e02.0203 on port gi0/4
within VLAN 8.
console(config)# interface vlan 8
console(config-if)# bridge multicast address 0100.5e02.0203
console(config-if)# bridge multicast forbidden address
0100.5e02.0203 add gi0/4
bridge multicast ip-address
Use the bridge multicast ip-address IInterface (VLAN) Configuration mode
command to register IP-layer Multicast addresses to the bridge table, and
statically add or remove ports to or from the group. Use the no form of this
command to unregister the IP address.