Dell PowerEdge VRTX - Manual (Page 280)

280 RADIUS Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\Radius.fm
D E L L C O N F ID E N T IA L – P R E L IM I N A RY 4 / 3 /1 4 - FO R P R O O F O N LY
Parameters
• interface-id —Specifies the source interface.
Default Configuration
The IPv6 source address is the IPv6 address defined on the outgoing interface
and selected in accordance with RFC6724.
Command Mode
Global Configuration mode
User Guidelines
If the source interface is the outgoing interface, the source IPv6 address is an
IPv6 address defined on the interfaces and selected in accordance with RFC
6724.
If the source interface is not the outgoing interface, the source IPv6 address is
the minimal IPv6 address defined on the source interface and matched to the
scope of the destination IPv6 address is applied.
If there is no available source IPv6 address, a SYSLOG message is issued when
attempting to communicate with an IPv6 RADIUS server.
Example
The following example configures the VLAN 10 as the source interface.
console(config)# radius-server host source-interface-ipv6
vlan 100
radius-server timeout
Use the radius-server timeout Global Configuration mode command to set
how long the device waits for a server host to reply. Use the no form of this
command to restore the default configuration.
Syntax
radius-server timeout timeout-seconds
no radius-server timeout