Dot1x timeout tx-period – Dell PowerEdge VRTX User Manual
Page 347

802.1X Commands
347
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\802_1X.fm
D E LL CO N F I D E N T IA L – P R E L I M I N A RY 4 / 3 / 14 - F O R PR O O F O N LY
User Guidelines
The default value of this command should be changed only to adjust to
unusual circumstances, such as unreliable links or specific behavioral
problems with certain clients and authentication servers.
The command is only applied to the 802.1x authentication method.
Example
The following example sets the time interval during which the device waits
for a response to an EAP request frame from the client before resending the
request to 3600 seconds.
console(config)# interface gi0/1
console(config-if)# dot1x timeout supp-timeout 3600
dot1x timeout tx-period
Use the dot1x timeout tx-period Interface Configuration mode command to
set the time interval during which the device waits for a response to an
Extensible Authentication Protocol (EAP) request/identity frame from the
client before resending the request. Use the no form of this command to
restore the default configuration.
Syntax
dot1x timeout tx-period
seconds
no dot1x timeout tx-period
Parameters
•
seconds
—Specifies the time interval in seconds during which the device
waits for a response to an EAP-request/identity frame from the client
before resending the request. (Range: 30–65535 seconds).
Default Configuration
The default timeout period is 30 seconds.
Command Mode
Interface (Ethernet) Configuration mode