Dell PowerEdge VRTX - Manual (Page 175)

SNMP Commands 175
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\SNMP.fm
D E LL CO N F I D E N T IA L – P R E L I M I N A RY 4 / 3 / 14 - F O R PR O O F O N LY
Default Configuration
The IPv6 source address is the IPv6 address of the outgoing interface and
selected in accordance with RFC6724.
If no parameters are specified in no snmp-server source-interface, the default
is both traps and informs.
Command Mode
Global Configuration mode
User Guidelines
If the source interface is the outgoing interface, the IPv6 address defined on
the interfaces is selected in accordance with RFC 6724.
If the source interface is not the outgoing interface, the minimal IPv6 address
defined on the source interface with the scope of the destination IPv6 address
is applied.
If there is no available IPv6 source address, a SYSLOG message is issued when
attempting to send an SNMP trap or inform.
Use the no snmp-server source-interface-ipv6 traps command to remove the
source IPv6 interface for SNMP traps.
Use the no snmp-server source-interface-ipv6 informs command to remove
the source IPv6 interface for SNMP informs.
Use the no snmp-server source-interface-ipv6 command to remove the
source IPv6 interface for SNMP traps and informs.
Example
The following example configures the VLAN 10 as the source interface.
console(config)# snmp-server source-interface-ipv6 traps vlan
100
snmp-server view
The snmp-server view Global Configuration mode command creates or
updates an SNMP view. Use the no form of this command to remove an
SNMP view.