Dell PowerEdge VRTX User Manual

Page 411

Address Table Commands

411

FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC

2+3\new_system_mifs_ARC2_latest\Address_Table.fm

D E LL CO N F I D E N T IA L – P R E L I M I N A RY 4 / 3 / 14 - F O R PR O O F O N LY

For each Forwarding Data Base (FDB) mode, use different CLI commands to

configure static entries in the FDB, as described in the following table:

The following table describes the actual data that is written to the Forwarding

Data Base (FDB) as a function of the IGMP version that is used in the

network:

(*) Note that (*,G) cannot be written to the FDB if the mode is ipv4-src-

group. In that case, no new FDB entry is created, but the port is added to the

static (S,G) entries (if they exist) that belong to the requested group. It is

recommended to set the FDB mode to ipv4-group or mac-group for IGMP

version 2.
If an application on the device requests (*,G), the operating FDB mode is

changed to
ipv4-group.

Example

The following example configures the Multicast bridging mode as an mac-

group on VLAN 2.

console(config)# interface vlan 2

console(config-if)# bridge multicast mode mac-group

FDB Mode

CLI Commands

mac-group

bridge multicast address

ipv4-group

bridge multicast ip-address bridge multicast forbidden ip-

ipv4-src-group

bridge multicast source

FDB mode

IGMP version 2

IGMP version 3

mac-group

MAC group address

ipv4-group

IP group address

ipv4-src-group

(*)

IP source and group addresses