Dell PowerEdge VRTX - Manual (Page 193)

SNMP Commands 193
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\SNMP.fm
D E LL CO N F I D E N T IA L – P R E L I M I N A RY 4 / 3 / 14 - F O R PR O O F O N LY
Default Configuration
SNMP traps are enabled.
Command Mode
Global Configuration mode
User Guidelines
If no snmp-server enable traps has been entered, you can enable failure traps
by using snmp-server trap authentication as shown in the example.
Example
The following example enables SNMP traps except for SNMP failure traps.
console(config)# snmp-server enable traps
console(config)# no snmp-server trap authentication
snmp-server trap authentication
Use the snmp-server trap authentication Global Configuration mode
command to enable the device to send SNMP traps when authentication
fails. Use the no form of this command to disable SNMP failed
authentication traps.
Syntax
snmp-server trap authentication
no snmp-server trap authentication
Parameters
N/A
Default Configuration
SNMP failed authentication traps are enabled.
Command Mode
Global Configuration mode