Dell PowerEdge VRTX - Manual (Page 387)

Template Last Updated - 2/7/2007 EEE Commands 387
D E LL CO N F I D E N T IA L – P R E L I M I N A RY 4 / 3 / 14 - F O R PR O O F O N LY
24
EEE Commands
NOTE: Some CLI commands or parameters described below are not applicable for
fiber ports. Refer to Port Features .
eee enable (global)
Use the eee enable Global Configuration command to enable the EEE mode
globally. Use the no format of the command to disable the mode.
Syntax
eee enable
no eee enable
Default Configuration
EEE is enabled.
Command Mode
Global Configuration mode
User Guidelines
In order for EEE to work, the device at the other end of the link must also
support EEE and have it enabled. In addition, for EEE to work properly, auto-
negotaition must be enabled; however, if the port speed is negotiated as
1Giga, EEE always works regardless of whether the auto-negotiation status is
enabled or disabled.
If auto-negotiation is not enabled on the port and its speed is less than 1
Giga, the EEE operational status is disabled.
Example
console(config)# eee enable