Dell PowerEdge VRTX - Manual (Page 777)

Quality of Service (QoS) Commands 777
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\QoS.fm
D E LL CO N F I D E N T IA L – P R E L I M I N A RY 4 / 3 / 14 - F O R PR O O F O N LY
indicates that the corresponding weight in the wrr-queue bandwidth
Interface Configuration mode command is ignored (not used in the ratio
calculation).
Example
The following example configures the number of expedite queues as 2.
console(config)# priority-queue out num-of-queues 2
traffic-shape
The egress port shaper controls the traffic transmit rate (Tx rate) on a port.
Use the traffic-shape Interface Configuration mode command to configure
the egress port shaper. Use the no form of this command to disable the
shaper.
Syntax
traffic-shape committed-rate [ committed-burst ]
no traffic-shape
Parameters
• committed-rate—Specifies the maximum average traffic rate (CIR) in
kbits per second (kbps). (Range: ,10GE: 64Kbps–maximum port speed))
• committed-burst—Specifies the maximum permitted excess burst size
(CBS) in bytes. (Range: 4096 - 16762902 bytes)
Default Configuration
The shaper is disabled.
Command Mode
Interface (Ethernet) Configuration mode