Dell PowerEdge VRTX - Manual (Page 570)

570 VLAN Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\VLAN.fm
D E L L C O N F ID E N T IA L – P R E L IM I N A RY 4 / 3 /1 4 - FO R P R O O F O N LY
ip internal-usage-vlan
The system assigns a VLAN to every IP address. In rare cases, this might
conflict with a user requirement for that VLAN. In this case, use the ip
internal-usage-vlan Interface Configuration mode command to reserve a
different VLAN as the internal usage VLAN of an interface. Use the no form
of this command to restore the default configuration.
Syntax
ip internal-usage-vlan vlan-id
no ip internal-usage-vlan
Parameters
• vlan-id —Specifies the internal usage VLAN ID.
Default Configuration
No VLAN is reserved as an internal usage VLAN by default (using this
command).
Command Mode
Interface (Ethernet, Port Channel) Configuration mode
User Guidelines
An internal usage VLAN is assigned by the system when an IP interface is
defined on an Ethernet port or port-channel.
If an internal usage VLAN is not defined for a port, the software selects one of
the unused VLANs.
If a VLAN was chosen by the software for internal usage, but you want to use
that VLAN for a static or dynamic VLAN, do one of the following:
• Remove the IP address from the interface (this releases the internal usage
VLAN).
• Recreate the VLAN on the required interface (now it will be assigned to
the interface and not be used as an internal usage VLAN)