Dell PowerEdge VRTX - Manual (Page 498)

498 Spanning-Tree Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\Spanning-Tree.fm
D E L L C O N F ID E N T IA L – P R E L IM I N A RY 4 / 3 /1 4 - FO R P R O O F O N LY
spanning-tree port-priority
Use the spanning-tree port-priority Interface (Ethernet, Port Channel)
Configuration mode command to configure the port priority. Use the no form
of this command to restore the default configuration.
Syntax
spanning-tree port-priority priority
no spanning-tree port-priority
Parameters
priority—Specifies the port priority. (Range: 0–240)
Default Configuration
The default port priority is 128.
Command Mode
Interface (Ethernet, Port Channel) Configuration mode
User Guidelines
The priority value must be a multiple of 16.
Example
The following example configures the spanning priority on gi0/4 to 96
console(config)# interface gi0/4
console(config-if)# spanning-tree port-priority 96
spanning-tree portfast
Use the spanning-tree portfast Interface (Ethernet, Port Channel)
Configuration mode command to enable the PortFast mode. In PortFast
mode, the interface is immediately put into the forwarding state upon linkup,
without waiting for the standard forward time delay. Use the no form of this
command to disable the PortFast mode.