Dell PowerEdge VRTX - Manual (Page 670)

670 IP Addressing Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\IP_Addressing_MeS.fm
D E L L C O N F ID E N T IA L – P R E L IM I N A RY 4 / 3 /1 4 - FO R P R O O F O N LY
• mac-address —MAC address to map to the specified IP address or IP alias.
• interface-id —Address pair is added for specified interface.
Command Mode
Global Configuration mode
Default Configuration
No permanent entry is defined.
If no interface ID is entered, address pair is relevant to all interfaces.
User Guidelines
The software uses ARP cache entries to translate 32-bit IP addresses into 48-
bit hardware (MAC) addresses. Because most hosts support dynamic address
resolution, static ARP cache entries generally do not need to be specified.
Example
The following example adds IP address 198.133.219.232 and MAC address
00:00:0c:40:0f:bc to the ARP table.
console(config)# arp 198.133.219.232 00:00:0c:40:0f:bc vlan100
arp timeout (Global)
Use the arp timeout Global Configuration mode command to set the time
interval during which an entry remains in the ARP cache. Use the no form of
this command to restore the default configuration.
Syntax
arp timeout seconds
no arp timeout
Parameters
• seconds —Specifies the time interval (in seconds) during which an entry
remains in the ARP cache. (Range: 1–40000000).