Dell PowerEdge VRTX - Manual (Page 500)

500 Spanning-Tree Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\Spanning-Tree.fm
D E L L C O N F ID E N T IA L – P R E L IM I N A RY 4 / 3 /1 4 - FO R P R O O F O N LY
• shared—Specifies that the port link type is shared.
Default Configuration
The device derives the port link type from the duplex mode. A full-duplex
port is considered a point-to-point link and a half-duplex port is considered a
shared link.
Command Mode
Interface (Ethernet, Port Channel) Configuration mode
Example
The following example enables shared spanning-tree on gi0/4.
console(config)# interface gi0/4
console(config-if)# spanning-tree link-type shared
spanning-tree pathcost method
Use the spanning-tree pathcost method Global Configuration mode
command to set the default path cost method. Use the no form of this
command to return to the default configuration.
Syntax
spanning-tree pathcost method {long | short}
no spanning-tree pathcost method
Parameters
• long — Specifies that the default port path costs are within the range:
1–200,000,000.
• short—Specifies that the default port path costs are within the range:
1–200,000,000.
Default Configuration
Long path cost method.