Dell PowerEdge VRTX - Manual (Page 689)

IPv6 Commands 689
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\IPv6_Router.fm
D E LL CO N F I D E N T IA L – P R E L I M I N A RY 4 / 3 / 14 - F O R PR O O F O N LY
console(config-if)# ipv6 nd dad attempts 5
console(config-if)# exit
console(config)# interface vlan 2
console(config-if)# ipv6 nd dad attempts 0
console(config-if)# exit
ipv6 neighbor
Use the ipv6 neighbor command in Global Configuration mode to configure
a static entry in the IPv6 neighbor discovery cache. To remove a static IPv6
entry from the IPv6 neighbor discovery cache, use the no form of this
command.
Syntax
ipv6 neighbor ipv6-address interface-id mac-address
no ipv6 neighbor [[ ipv6-address ] interface-id ]
Parameters
• ipv6-address —Specified IPv6 address. This argument must be in the form
documented in RFC4293 where the address is specified in hexadecimal
using 16-bit values between colons.
• interface-id —Specified interface identifier.
• mac-address —Interface MAC address.
Default Configuration
Static entries are not configured in the IPv6 neighbor discovery cache.
Command Mode
Global Configuration mode
User Guidelines
This command is similar to the arp (global) command.
Use the ipv6 neighbor command to add a static entry in the IPv6 neighbor
discovery cache.