Dell PowerEdge VRTX - Manual (Page 827)

MLD Commands 827
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\MLD.fm
D E LL CO N F I D E N T IA L – P R E L I M I N A RY 4 / 3 / 14 - F O R PR O O F O N LY
ipv6 mld query-interval
To configure the frequency at which the switch sends Multicast Listener
Discovery (MLD) host-query messages, use the ipv6 mld query-interval
command in interface configuration mode. To return to the default
frequency, use the no form of this command.
Syntax
ipv6 mld query-interval seconds
no ipv6 mld query-interval
Parameters
• seconds —Frequency, in seconds, at which the switch sends MLD query
messages from the interface. The range is from 1 to 31744.
Default Configuration
The default MLD query interval is 125 seconds.
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
Use the ipv6 mld query-interval command to configure the frequency at
which the MLD querier sends MLD host-query messages from an interface.
The MLD querier sends query-host messages to discover which multicast
groups have members on the attached networks of the router.
The query interval must be bigger than the maximum query response time.
Example
The following example shows how to increase the frequency at which the
MLD querier sends MLD host-query messages to 180 seconds:
console(config)# interface vlan 100
console(config-if)# ipv6 mld query-interval 180
console(config-if)# exit