Dell PowerEdge VRTX - Manual (Page 422)

422 Address Table Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\Address_Table.fm
D E L L C O N F ID E N T IA L – P R E L IM I N A RY 4 / 3 /1 4 - FO R P R O O F O N LY
bridge multicast ipv6 ip-address
Use the bridge multicast ipv6 ip-address IInterface (VLAN) Configuration
mode command to register an IPv6 Multicast address to the bridge table, and
statically add or remove ports to or from the group. Use the no form of this
command to unregister the IPv6 address.
Syntax
bridge multicast ipv6 ip-address ipv6-multicast-address [[add | remove]
{ethernet interface-list |
port-channel port-channel-list}]
no bridge multicast ipv6 ip-address ip-multicast-address
Parameters
• ipv6-multicast-address—Specifies the group IPv6 multicast address.
•
add—Adds ports to the group.
• remove—Removes ports from the group.
• ethernet interface-list —Specifies a list of Ethernet ports. Separate
nonconsecutive Ethernet ports with a comma and no spaces; use a hyphen
to designate a range of ports.
• port-channel port-channel-list —Specifies a list of port channels. Separate
nonconsecutive port-channels with a comma and no spaces. Use a hyphen
to designate a range of port channels.
Default Configuration
No Multicast addresses are defined.
The default option is add.
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
To register the group in the bridge database without adding or removing ports
or port channels, specify the ipv6-multicast-address parameter only.
Static Multicast addresses can be defined on static VLANs only.