Ipv6 mld query-max-response-time, Ipv6 mld query-max, Response-time – Dell PowerEdge VRTX User Manual
Page 828

828
MLD Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\MLD.fm
D E L L C O N F ID E N T IA L – P R E L IM I N A RY 4 / 3 /1 4 - FO R P R O O F O N LY
ipv6 mld query-max-response-time
To configure the maximum response time advertised in Multicast Listener
Discovery (MLD) queries, use the ipv6 mld query-max-response-time
command in interface configuration mode. To restore the default value, use
the no form of this command.
Syntax
ipv6 mld query-max-response-time
seconds
no ipv6 mld query-max-response-time
Parameters
•
seconds
—Maximum response time, in seconds, advertised in MLD
queries. (Range: 0–31744)
Default Configuration
10 seconds.
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
This command controls the period during which the responder can respond
to an MLD query message before the router deletes the group.
This command controls how much time the hosts have to answer an MLD
query message before the router deletes their group. Configuring a value of
fewer than 10 seconds enables the router to prune groups faster.
The maximum query response time must be less than the query interval.
NOTE:
If the hosts do not respond fast enough, they might be pruned inadvertently.
Therefore, the hosts must know to respond faster than 10 seconds (or the value you
configure).