Dell PowerEdge VRTX - Manual (Page 130)

130 Clock Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\Clock.fm
D E L L C O N F ID E N T IA L – P R E L IM I N A RY 4 / 3 /1 4 - FO R P R O O F O N LY
Syntax
sntp server { ip-address | hostname } [poll] [key keyid ]
no sntp server [ ip-address | hostname ]
Parameters
• ip-address —Specifies the server IP address. This can be an IPv4, IPv6 or
IPv6z address.
• hostname —Specifies the server hostname. Only translation to IPv4
addresses is supported. (Length: 1–158 characters. Maximum label length
for each part of the hostname: 63 characters)
• poll—Enables polling.
• key keyid —Specifies the Authentication key to use when sending packets
to this peer. (Range:1–4294967295)
Default Configuration
No servers are defined.
Command Mode
Global Configuration mode
User Guidelines
Use the sntp server { ip-address | hostname } [poll] [key keyid ] command to
define a SNTP server. The switch supports up to 8 SNTP servers.
Use the no sntp server
ip-address | hostname command to remove one SNTP
server.
Use the no sntp server to remove all SNTP servers.
Example
The following example configures the device to accept SNTP traffic from the
server on 192.1.1.1 with polling.
console(config)# sntp server 192.1.1.1 poll