Dell PowerEdge VRTX - Manual (Page 820)

820 MLD Snooping Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\MLD_Snooping.fm
D E L L C O N F ID E N T IA L – P R E L IM I N A RY 4 / 3 /1 4 - FO R P R O O F O N LY
User Guidelines
Static multicast addresses can only be defined on static VLANs.
You can execute the command before the VLAN is created.
You can register an entry without specifying an interface.
Using the no command without a port-list removes the entry.
Example
console(config)# ipv6 mld snooping vlan 1 static FF12::3
gi0/1
ipv6 mld snooping vlan immediate-leave
Use the ipv6 mld snooping vlan immediate-leave Global Configuration
mode command to enable MLD Snooping Immediate-Leave processing on a
VLAN. When an MLD Leave Group message is received from a host, the
system removes the host port from the table entry. After it relays the MLD
queries from the Multicast router, it deletes entries periodically if it does not
receive any MLD membership reports from the Multicast clients.
MLD snooping Immediate-Leave processing allows the switch to remove an
interface that sends a leave message from the forwarding table without first
sending out MAC-based general queries to the interface.
Use the no format of the command to return to disable MLD Snooping
Immediate-Leave processing.
Syntax
ipv6 mld snooping vlan vlan-id immediate-leave
no ipv6 mld snooping vlan vlan-id immediate-leave
Parameters
vlan-id —Specifies the VLAN ID value. (Range: 1–4094)
Default Configuration
Disabled