Dell PowerEdge VRTX - Manual (Page 359)

Template Last Updated - 2/7/2007 Ethernet Configuration Commands 359
D E LL CO N F I D E N T IA L – P R E L I M I N A RY 4 / 3 / 14 - F O R PR O O F O N LY
22
Ethernet Configuration Commands
NOTE: Some CLI commands or parameters described below are not applicable for
fiber ports. Refer to Port Features .
interface
Use the interface Global Configuration mode command to enter Interface
configuration mode in order to configure an interface.
Syntax
interface interface-id
Parameters
interface-id—Specifies an interface ID. The interface ID can be one of the
following types: Ethernet port, port-channel, VLAN, range, OOB, IP interface
or tunnel.
Default Configuration
N/A
Command Mode
Global Configuration mode
Examples
Example 1—For Ethernet ports:
console(config)# interface gi0/1
console(config-if)#
Example 2—For port channels (LAGs):
console(config)# interface po1
console(config-if)#