Dell PowerEdge VRTX - Manual (Page 410)

410 Address Table Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\Address_Table.fm
D E L L C O N F ID E N T IA L – P R E L IM I N A RY 4 / 3 /1 4 - FO R P R O O F O N LY
bridge multicast mode
Use the bridge multicast mode IInterface (VLAN) Configuration mode
command to configure the Multicast bridging mode. Use the no form of this
command to return to the default configuration.
Syntax
bridge multicast mode {mac-group | ipv4-group | ipv4-src-group}
no bridge multicast mode
Parameters
• mac-group—Specifies that Multicast bridging is based on the packet's
VLAN and MAC address.
• ipv4-group—Specifies that Multicast bridging is based on the packet's
VLAN and MAC address for non-IPv4 packets, and on the packet's VLAN
and IPv4 destination address for IPv4 packets.
• ipv4-src-group—Specifies that Multicast bridging is based on the packet's
VLAN and MAC address for non-IPv4 packets, and on the packet's VLAN,
IPv4 destination address and IPv4 source address for IPv4 packets.
Default Configuration
The default mode is mac-group.
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
Use the mac-group option when using a network management system that
uses a MIB based on the Multicast MAC address. Otherwise, it is
recommended to use the ipv4 mode, because there is no overlapping of IPv4
Multicast addresses in these modes.