Deny (management) – Dell PowerEdge VRTX User Manual
Page 164

164
Management ACL Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\Management_ACL.fm
D E L L C O N F ID E N T IA L – P R E L IM I N A RY 4 / 3 /1 4 - FO R P R O O F O N LY
deny (Management)
The deny Management Access-list Configuration mode command sets
permit rules (ACEs) for the management access list (ACL).
Syntax
deny
[interface-id] [service service]
deny ip-source
{ipv4-address | ipv6-address/ipv6-prefix-length} [mask {mask
| prefix-length}] [interface-id] [service service]
Parameters
• interface-id—Specifies an interface ID. The interface ID can be one of the
following types: Ethernet port, Port-channel or VLAN
•
service
service
—Specifies the service type. Possible values are: Telnet,
SSH, HTTP, HTTPS and SNMP.
•
ipv4-address—Specifies the source IPv4 address.
•
ipv6-address/ipv6-prefix-length—Specifies the source IPv6 address and
source IPv6 address prefix length. The prefix length must be preceded by a
forward slash (/). The parameter is optional.
•
mask
mask
—Specifies the source IPv4 address network mask. The
parameter is relevant only to IPv4 addresses.
•
mask
prefix-length
—Specifies the number of bits that comprise the source
IPv4 address prefix. The prefix length must be preceded by a forward slash
(/). The parameter is relevant only to IPv4 addresses. (Range: 0–32)
Default Configuration
No rules are configured.
Command Mode
Management Access-list Configuration mode
User Guidelines
Rules with ethernet, VLAN, and port-channel parameters are valid only if an
IP address is defined on the appropriate interface.