Dell PowerEdge VRTX - Manual (Page 171)

SNMP Commands 171
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\SNMP.fm
D E LL CO N F I D E N T IA L – P R E L I M I N A RY 4 / 3 / 14 - F O R PR O O F O N LY
Default Configuration
No community is defined
Command Mode
Global Configuration mode
User Guidelines
The logical key of the command is the pair (community, ip-address). If ip-
address is omitted, the key is (community, All-IPs). This means that there
cannot be two commands with the same community, ip address pair.
The
view-name is used to restrict the access rights of a community string.
When a view-name is specified, the software:
• Generates an internal security-name.
• Maps the internal security-name for SNMPv1 and SNMPv2 security
models to an internal group-name.
• Maps the internal group-name for SNMPv1 and SNMPv2 security models
to view-name (read-view and notify-view always, and for rw for write-view
also),
Example
Defines a password for administrator access to the management station at IP
address 1.1.1.121 and mask 255.0.0.0.
console(config)# snmp-server community abcd su 1.1.1.121 mask
255.0.0.0
snmp-server community-group
Use snmp-server community-group to configure access rights to a user group.
The group must exist in order to be able to specify the access rights. This
command configures both SNMP v1 and v2.
Syntax
snmp-server community-group community - string group-name [ip-address |
ipv6-address] [ mask mask | prefix prefix-length] [type {router | oob}]