Dell PowerEdge VRTX - Manual (Page 767)

Quality of Service (QoS) Commands 767
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\QoS.fm
D E LL CO N F I D E N T IA L – P R E L I M I N A RY 4 / 3 / 14 - F O R PR O O F O N LY
set
Use the set Policy-map Class Configuration mode command to select the
value that QoS uses as the DSCP value, the egress queue or to set user
priority values.
This command is only available when QoS is in advanced mode.
Syntax
set {dscp new-dscp | queue queue-id | cos new-cos }
no set
Parameters
• dscp new-dscp —Specifies the new DSCP value for the classified traffic.
(Range: 0–63)
• queue queue-id —Specifies the egress queue. (Range: 1-8 )
• cos new-cos —Specifies the new user priority to be marked in the packet.
(Range: 0–7)
Command Mode
Policy-map Class Configuration mode.
User Guidelines
The set and trust commands are mutually exclusive within the same policy
map.
To return to the Configuration mode, use the exit command. To return to the
Privileged EXEC mode, use the end command.
Example
The following example creates an ACL, places it into a class map, places the
class map into a policy map and sets the DSCP value in the packet to 56 for
classes in the policy map called p1.
console(config)# ip access-list extended ip1
console(config-ip-al)# permit ip any any
console(config-ip-al)# exit