Dell PowerEdge VRTX - Manual (Page 681)

IPv6 Commands 681
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\IPv6_Router.fm
D E LL CO N F I D E N T IA L – P R E L I M I N A RY 4 / 3 / 14 - F O R PR O O F O N LY
configuration on an interface and enable IPv6 processing on the interface.
Addresses are configured depending on the prefixes received in Router
Advertisement messages.
To remove the address from the interface, use the no form of this command.
Syntax
ipv6 address autoconfig
no ipv6 address autoconfig
Parameters
N/A.
Default Configuration
Stateless Auto configuration is disabled.
Command Mode
Interface Configuration mode
User Guidelines
This command enables IPv6 on an interface (if it was disabled) and causes
the switch to perform IPv6 stateless address auto-configuration to discover
prefixes on the link and then to add the eui-64 based addresses to the
interface.
Stateless auto configuration is applied only when IPv6 Forwarding is disabled.
When IPv6 forwarding is changed from disabled to enabled, and stateless
auto configuration is enabled the switch stops stateless auto configuration
and removes all stateless auto configured ipv6 addresses from all interfaces.
When IPv6 forwarding is changed from enabled to disabled and stateless auto
configuration is enabled the switch resumes stateless auto configuration.
Using the no ipv6 address autoconfig command to disable stateless auto
configuration and to remove all stateless auto configured IPv6 addresses from
an interface.