Dell PowerEdge VRTX - Manual (Page 415)

Address Table Commands 415
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\Address_Table.fm
D E LL CO N F I D E N T IA L – P R E L I M I N A RY 4 / 3 / 14 - F O R PR O O F O N LY
Syntax
bridge multicast ip-address ip-multicast-address [[add | remove] {interface-
list | port-channel port-channel-list }]
no bridge multicast ip-address ip-multicast-address
Parameters
• ip-multicast-address—Specifies the group IP Multicast address.
•
add—Adds ports to the group.
• remove—Removes ports from the group.
• interface-list —Specifies a list of Ethernet ports. Separate nonconsecutive
Ethernet ports with a comma and no spaces. Use a hyphen to designate a
range of ports.
• port-channel port-channel-list —Specifies a list of port channels. Separate
nonconsecutive port-channels with a comma and no spaces. Use a hyphen
to designate a range of port channels.
Default Configuration
No Multicast addresses are defined.
Default option is add.
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
To register the group in the bridge database without adding or removing ports
or port channels, specify the ip-multicast-address parameter only.
Static Multicast addresses can be defined on static VLANs only.
You can execute the command before the VLAN is created.
Example
The following example registers the specified IP address to the bridge table:
console(config)# interface vlan 8