Dell PowerEdge VRTX - Manual (Page 547)

VLAN Commands 547
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\VLAN.fm
D E LL CO N F I D E N T IA L – P R E L I M I N A RY 4 / 3 / 14 - F O R PR O O F O N LY
no switchport trunk native vlan
Parameters
• vlan-id —Specifies the native VLAN ID.
• none—Specifies the access port cannot belong to any VLAN.
Default Configuration
The default native VLAN is the Default VLAN.
Command Mode
Interface (Ethernet, Port Channel) Configuration mode
User Guidelines
If the interface does not belong to the VLAN it is added to the VLAN, if the
interface is not a forbidden member of this VLAN. If the interface is a
forbidden member of an added VLAN, the interface does not become a
member of this specific VLAN and an error message is displayed. This
message will only be displayed once.") and the command continues to
execute if there are more VLANs in the vlan-list.
The interface is set as VLAN untagged egress interface. A value of the
interface PVID is set to this VLAN ID.
The configuration is applied only when the port mode is trunk.
Examples
The following example defines VLAN 2 as native VLAN for port
gi0/
1
:
console(config)# interface gi0/1
console(config-if)# switchport trunk native vlan 2
console(config-if)# exit
switchport general allowed vlan
General ports can receive tagged or untagged packets. Use the switchport
general allowed vlan Interface Configuration mode command to add/remove