Dell PowerEdge VRTX - Manual (Page 366)

366 Ethernet Configuration Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\Ethernet.fm
D E L L C O N F ID E N T IA L – P R E L IM I N A RY 4 / 3 /1 4 - FO R P R O O F O N LY
Example
The following example enables auto-negotiation on gi0/1.
console(config)# interface gi0/ 1
console(config-if)# negotiation
flowcontrol
Use the flowcontrol Interface (Ethernet, Port Channel) Configuration mode
command to configure the Flow Control on a given interface. Use the no
form of this command to disable Flow Control.
Syntax
flowcontrol {auto | on | off}
no flowcontrol
Parameters
• auto—Specifies auto-negotiation of Flow Control.
•
on—Enables Flow Control.
• off—Disables Flow Control.
Default Configuration
Flow control is Disabled.
Command Mode
Interface (Ethernet, Port Channel) Configuration mode
User Guidelines
Use the negotiation command to enable flow control auto.
Flow Control is not supported on 10G fiber ports.
Example
The following example enables Flow Control on port gi0/1
console(config)# interface gi0/1