Dell PowerEdge VRTX - Manual (Page 132)

132 Clock Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\Clock.fm
D E L L C O N F ID E N T IA L – P R E L IM I N A RY 4 / 3 /1 4 - FO R P R O O F O N LY
sntp source-interface-ipv6
Use the sntp source-interface-ipv6 Global Configuration mode command to
specify the source interface whose IPv6 address will be used ad the Source
IPv6 address for communication with IPv6 SNTP servers. Use the no form of
this command to restore the default configuration.
Syntax
sntp source-interface-ipv6 interface-id
no sntp source-interface-ipv6
Parameters
• interface-id —Specifies the source interface.
Default Configuration
The IPv6 source address is the IPv6 address defined of the outgoing interface
and selected in accordance with RFC6724.
Command Mode
Global Configuration mode
User Guidelines
The outgoing interface is selected based on the SNTP server's IP address. If
the source interface is the outgoing interface, the IPv6 address defined on the
interfaces and selected in accordance with RFC 6724.
If the source interface is not the outgoing interface, the minimal IPv4 address
defined on the interface and with the scope of the destination IPv6 address is
applied.
If there is no available IPv6 source address, a SYSLOG message is issued when
attempting to communicate with an IPv6 SNTP server.
Example
The following example configures the VLAN 10 as the source interface.
console(config)# sntp source-interface-ipv6 vlan 10