Dell PowerEdge VRTX - Manual (Page 497)

Spanning-Tree Commands 497
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\Spanning-Tree.fm
D E LL CO N F I D E N T IA L – P R E L I M I N A RY 4 / 3 / 14 - F O R PR O O F O N LY
spanning-tree cost
Use the spanning-tree cost Interface (Ethernet, Port Channel) Configuration
mode command to configure the spanning-tree path cost for a port. Use the
no form of this command to restore the default configuration.
Syntax
spanning-tree cost cost
no spanning-tree cost
Parameters
cost—Specifies the port path cost. (Range: 1–200000000)
Default Configuration
Default path cost is determined by port speed and path cost method (long or
short) as shown below
Command Mode
Interface (Ethernet, Port Channel) Configuration mode
Example
The following example configures the spanning-tree cost on gi0/4 to 35000.
console(config)# interface gi0/4
console(config-if)# spanning-tree cost 35000
Interface Long Short
Port-channel 20,000 4
TenGigabit Ethernet (10000 Mbps) 2000 2
Gigabit Ethernet (1000 Mbps) 20,000 4
Ethernet (10 Mbps) 2,000,000 100