Dell PowerEdge VRTX - Manual (Page 718)

718 IP Routing Protocol-Independent Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\IP_Routing_MeS.fm
D E L L C O N F ID E N T IA L – P R E L IM I N A RY 4 / 3 /1 4 - FO R P R O O F O N LY
show ip route
To display the current state of the routing table, use the show ip route
command in user EXEC or privileged EXEC mode.
Syntax
show ip route [address ip-address { mask [longer-prefixes]} [static | rejected
| icmp | connected]
Parameters
• address ip-address —IP address about which routing information should be
displayed.
• mask —The value of the subnet mask.
• longer-prefixes—Specifies that only routes matching the IP address and
mask pair should be displayed.
• connected—Displays connected routes.
• icmp—Displays routes added by ICMP Direct.
• rejected—Displays rejected routes.
• static—Displays static routes.
Command Mode
User EXEC mode
Privileged EXEC mode
User Guidelines
Use this command without parameters to display the whole IPv6 Routing
table.
Use this command with parameters to specify required routes.
Examples
Example 1. The following is sample output from the show ip route command
when IP Routing is not enabled:
console# show ip route