Dell PowerEdge VRTX - Manual (Page 289)

TACACS+ Commands 289
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\TACACS.fm
D E LL CO N F I D E N T IA L – P R E L I M I N A RY 4 / 3 / 14 - F O R PR O O F O N LY
Example
The following example configures the VLAN 10 as the source interface.
console(config)# tacacs-server host source-interface vlan 100
tacacs-server host source-interface-ipv6
Use the tacacs-server host source-interface-ipv6 Global Configuration mode
command to specify the source interface whose IPv6 address will be used as
the Source IPv6 address for communication with IPv6 TACACS+ servers.
Use the no form of this command to restore the default configuration.
Syntax
tacacs-server host source-interface-ipv6 interface-id
no tacacs-server host source-interface-ipv6
Parameters
• interface-id —Specifies the source interface.
Default Configuration
The IPv6 source address is the IPv6 address defined on the outgoing interface
and selected in accordance with RFC6724.
Command Mode
Global Configuration mode
User Guidelines
If the source interface is the outgoing interface, the source IPv6 address is an
IPv6 address defined on the interfaces and selected in accordance with RFC
6724.
If the source interface is not the outgoing interface, the source IPv6 address is
the minimal IPv6 address defined on the source interface and matched to the
scope of the destination IPv6 address is applied.
If there is no available source IPv6 address, a SYSLOG message is issued when
attempting to communicate with an IPv6 TACACS+ server.