Tacacs-server host source-interface – Dell PowerEdge VRTX User Manual
Page 288

288
TACACS+ Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\TACACS.fm
D E L L C O N F ID E N T IA L – P R E L IM I N A RY 4 / 3 /1 4 - FO R P R O O F O N LY
Example
The following example sets the timeout value to 30 for all TACACS+ servers.
console(config)# tacacs-server timeout 30
tacacs-server host source-interface
Use the tacacs-server host source-interface Global Configuration mode
command to specify the source interface which IPv4 address will be used as
the Source IPv4 address for communication with IPv4 TACACS+ servers.
Use the no form of this command to restore the default configuration.
Syntax
tacacs-server host source-interface
interface-id
no tacacs-server host source-interface
Parameters
•
interface-id
—Specifies the source interface.
Default Configuration
The source IPv4 address is the IPv4 address defined on the outgoing interface
and belonging to next hop IPv4 subnet.
Command Mode
Global Configuration mode
User Guidelines
If the source interface is the outgoing interface, the interface IP address
belonging to next hop IPv4 subnet is applied.
If the source interface is not the outgoing interface, the minimal IPv4 address
defined on the source interface is applied.
If there is no available IPv4 source address, a SYSLOG message is issued when
attempting to communicate with an IPv4 TACACS+ server.