Dell PowerEdge VRTX - Manual (Page 742)

742 ACL Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\ACL.fm
D E L L C O N F ID E N T IA L – P R E L IM I N A RY 4 / 3 /1 4 - FO R P R O O F O N LY
• source-wildcard —Wildcard bits to be applied to the source MAC address.
Use ones in the bit position that you want to be ignored.
• destination —Destination MAC address of the packet.
• destination-wildcard —Wildcard bits to be applied to the destination
MAC address. Use 1s in the bit position that you want to be ignored.
• eth-type —The Ethernet type in hexadecimal format of the packet.
• vlan-id —The VLAN ID of the packet. (Range: 1–4094).
• cos —The Class of Service of the packet.(Range: 0–7).
• cos-wildcard —Wildcard bits to be applied to the CoS.
• time-range-name—Name of the time range that applies to this permit
statement. (Range: 1–32)
• disable-port—The Ethernet interface is disabled if the condition is
matched.
• log-input—Specifies sending an informational syslog message about the
packet that matches the entry. Because forwarding/dropping is done in
hardware and logging is done in software, if a large number of packets
match an ACE containing a log-input keyword, the software might not be
able to match the hardware processing rate, and not all packets will be
logged.
Default Configuration
No MAC access list is defined.
Command Mode
MAC Access-list Configuration mode
Example
console(config)# mac access-list extended server1
console(config-mac-al)# deny 00:00:00:00:00:01 00:00:00:00:00:ff
any