Ip routing protocol-independent commands, Ip route, 41 ip routing protocol-independent commands 715 – Dell PowerEdge VRTX User Manual
Page 715
Template Last Updated - 2/7/2007
IP Routing Protocol-Independent Commands
715
D E LL CO N F I D E N T IA L – P R E L I M I N A RY 4 / 3 / 14 - F O R PR O O F O N LY
43
IP Routing Protocol-Independent
Commands
ip route
To establish static routes, use the ip route command in global configuration
mode. To remove static routes, use the no form of this command.
Syntax
ip route
prefix
{
mask
| /
prefix-length
} {{
ip-address
[metric
value
]}}
no ip route
prefix
{
mask
| /
prefix-length
} [
ip-address
]
Parameters
•
prefix
—IP route prefix for the destination.
•
mask
—Prefix mask for the destination.
•
/
prefix-length
—Prefix mask for the destination.Specifies the number of
bits that comprise the IP address prefix. The prefix length must be
preceded by a forward slash (/). (Range: 0–32)
•
ip-address
—IP address of the next hop that can be used to reach that
network.
•
metric
value
—Metric of the route. The default metric is 1 for the Next
Hop on an In-Band interface and 1 for the Next Hop on OOB. Range:
1–255.
Default Configuration
No static routes are established.
Command Mode
Global Configuration mode