Dell PowerEdge VRTX - Manual (Page 194)

194 SNMP Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\SNMP.fm
D E L L C O N F ID E N T IA L – P R E L IM I N A RY 4 / 3 /1 4 - FO R P R O O F O N LY
User Guidelines
The command snmp-server enable traps enables all traps including failure
traps. Therefore, if that command is enabled (it is enabled by default), this
command is not necessary.
Example
The following example disables all SNMP traps and enables only failed
authentication traps.
console(config)# no snmp-server enable traps
console(config)# snmp-server trap authentication
snmp-server contact
Use the snmp-server contact Global Configuration mode command to set the
value of the system contact (sysContact) string. Use the no form of the
command to remove the system contact information.
Syntax
snmp-server contact text
no snmp-server contact
Parameters
text—Specifies system contact information. (Length: 1–160 characters)
Default Configuration
N/A
Command Mode
Global Configuration mode
Example
The following example sets the system contact information to
Technical_Support.
console(config)# snmp-server contact Technical_Support