Port security routed secure-address – Dell PowerEdge VRTX User Manual
Page 438

438
Address Table Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\Address_Table.fm
D E L L C O N F ID E N T IA L – P R E L IM I N A RY 4 / 3 /1 4 - FO R P R O O F O N LY
Default Configuration
This default maximum number of addresses is 1.
Command Mode
Interface (Ethernet, Port Channel) Configuration mode
User Guidelines
The command may be used only when the interface in the regular (non-
secure with unlimited MAC learning) mode.
Use this command to change the default value before the
command.
Example
The following example sets the port to limited learning mode:
console(config)# interface gi0/4
console(config-if)# port security mode max
console(config-if)# port security max 20
console(config-if)# port security
console(config-if)# exit
port security routed secure-address
Use the port security routed secure-address Interface (Ethernet, Port
Channel) Configuration mode command to add a MAC-layer secure address
to a routed port. (port that has an IP address defined on it). Use the no form
of this command to delete a MAC address from a routed port.
Syntax
port security routed secure-address
mac-address
no port security routed secure-address
mac-address
Parameters
mac-address—Specifies the MAC address.