Dell PowerEdge VRTX - Manual (Page 770)

770 Quality of Service (QoS) Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\QoS.fm
D E L L C O N F ID E N T IA L – P R E L IM I N A RY 4 / 3 /1 4 - FO R P R O O F O N LY
Command Mode
Interface (Ethernet) Configuration mode
User Guidelines
Only one policy map per interface per direction is supported.
Example
Example 1—The following example attaches a policy map called Policy1 to
the input interface.
console(config-if)# service-policy input policy1
qos aggregate-policer
Use the qos aggregate-policer Global Configuration mode command to
define the policer parameters that can be applied to multiple traffic classes.
Use the no form of this command to remove an existing aggregate policer.
This command is only available when QoS is in advanced mode.
Syntax
qos aggregate-policer aggregate-policer-name committed-rate-kbps excess-
burst-byte [ exceed-action {drop | policed-dscp-transmit}]
no qos aggregate-policer aggregate-policer-name
Parameters
• aggregate-policer-name—Specifies the aggregate policer name.
•
committed-rate-kbps—Specifies the average traffic rate (CIR) in kbits per
second (kbps). (Range: 3–maximal port speed)
• excess-burst-byte—Specifies the normal burst size (CBS) in bytes. (Range:
3000–19173960)
• exceed-action { drop | policed-dscp-transmit} —Specifies the action taken
when the rate is exceeded. The possible values are:
–
drop—Drops the packet.