Dell PowerEdge VRTX - Manual (Page 418)

418 Address Table Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\Address_Table.fm
D E L L C O N F ID E N T IA L – P R E L IM I N A RY 4 / 3 /1 4 - FO R P R O O F O N LY
• ethernet interface-list —Specifies a list of Ethernet ports. Separate
nonconsecutive Ethernet ports with a comma and no spaces. Use a hyphen
to designate a range of ports.
• port-channel port-channel-list —Specifies a list of port channels. Separate
nonconsecutive port-channels with a comma and no spaces; use a hyphen
to designate a range of port channels.
Default Configuration
No Multicast addresses are defined.
The default option is add.
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
You can execute the command before the VLAN is created.
Example
The following example registers a source IP address - Multicast IP address pair
to the bridge table:
console(config)# interface vlan 8
console(config-if)# bridge multicast source 13.16.1.1 group
239.2.2.2
bridge multicast forbidden source group
Use the bridge multicast forbidden source group IInterface (VLAN)
Configuration mode command to forbid adding or removing a specific IP
source address - Multicast address pair to or from specific ports. Use the no
form of this command to return to the default configuration.
Syntax
bridge multicast forbidden source ip-address group ip-multicast-address
{ add | remove} {ethernet interface-list | port-channel port-channel-list}
no bridge multicast forbidden source ip-address group ip-multicast-address