Dell PowerEdge VRTX - Manual (Page 825)

Template Last Updated - 2/7/2007 MLD Commands 825
D E LL CO N F I D E N T IA L – P R E L I M I N A RY 4 / 3 / 14 - F O R PR O O F O N LY
48
MLD Commands
ipv6 mld last-member-query-count
To configure the Multicast Listener Discovery (MLD) last member query
counter, use the ipv6 mld last-member-query-count command in interface
configuration mode. To restore the default value, use the no form of this
command.
Syntax
ipv6 mld last-member-query-count count
no ipv6 mld last-member-query-count
Parameters
count—The number of times that group- or group-source-specific queries are
sent upon receipt of a message indicating a leave. (Range: 1–7)
Default Configuration
A value of MLD Robustness variable.
Command Mode
Interface configuration
User Guidelines
Use the ipv6 mld robustness command to change the MLD last member
query counter.
Example
The following example changes a value of the MLD last member query
counter to 3:
interface vlan 1
ipv6 mld last-member-query-count 3