Radius commands, Radius-server host, 15 radius commands – Dell PowerEdge VRTX User Manual
Page 275
Template Last Updated - 2/7/2007
RADIUS Commands
275
D E LL CO N F I D E N T IA L – P R E L I M I N A RY 4 / 3 / 14 - F O R PR O O F O N LY
17
RADIUS Commands
radius-server host
Use the radius-server host Global Configuration mode command to configure
a RADIUS server host. Use the no form of the command to delete the
specified RADIUS server host.
Syntax
radius-server host {
ip-address | hostname
} [auth-port
auth-port-number
]
[acct-port
acct-port-number
] [timeout
timeout
] [retransmit
retries
]
[deadtime
deadtime
] [key
key-string
] [source
source-ip
] [priority
priority
]
[usage {login
|
dot1.x
|
all}]
no radius-server host {
ip-address
|
hostname
}
Parameters
•
ip-address
—Specifies the RADIUS server host IP address. The IP address
can be an IPv4, IPv6 or IPv6z address. See
•
hostname
—Specifies the RADIUS server host name. Translation to IPv4
addresses only is supported. (Length: 1–158 characters. Maximum label
length of each part of the hostname: 63 characters)
•
auth-port
auth-port-number
—Specifies the port number for
authentication requests. If the port number is set to 0, the host is not used
for authentication. (Range: 0–65535)
•
acct-port
acct-port-number
—Port number for accounting requests. The
host is not used for accountings if set to 0. If unspecified, the port number
defaults to 1813.
•
timeout
timeout
—Specifies the timeout value in seconds. (Range: 1–30)
•
retransmit
retries
—Specifies the number of retry retransmissions (Range:
1–15)
•
deadtime
deadtime
—Specifies the length of time in minutes during which
a RADIUS server is skipped over by transaction requests. (Range: 0–2000)