Dell PowerEdge VRTX - Manual (Page 779)

Quality of Service (QoS) Commands 779
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\QoS.fm
D E LL CO N F I D E N T IA L – P R E L I M I N A RY 4 / 3 / 14 - F O R PR O O F O N LY
Example
The following example sets a shaper on queue 1 on gi0/1 when the average
traffic rate exceeds 124000 kbps or the normal burst size exceeds 9600 bytes.
console(config)# interface gi0/1
console(config-if)# traffic-shape queue 1 64 4096
rate-limit (Ethernet)
Use the rate-limit Interface Configuration mode command to limit the
incoming traffic rate on a port. Use the no form of this command to disable
the rate limit.
Syntax
rate-limit committed-rate-kbps [burst committed-burst-bytes]
no rate-limit
Parameters
• committed-rate-kbps—Specifies the maximum number of kilobits per
second of ingress traffic on a port. The range is 3–maximal port speed.
• burst committed-burst-bytes —The burst size in bytes. (Range:
3000–19173960). If unspecified, defaults to 128K.
Default Configuration
Rate limiting is disabled.
Committed-burst-bytes is 128K.
Command Mode
Interface (Ethernet) Configuration mode
User Guidelines
Storm control and rate-limit (of Unicast packets) cannot be enabled
simultaneously on the same port.