Dell PowerEdge VRTX - Manual (Page 131)

Clock Commands 131
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\Clock.fm
D E LL CO N F I D E N T IA L – P R E L I M I N A RY 4 / 3 / 14 - F O R PR O O F O N LY
sntp source-interface
Use the sntp source-interface Global Configuration mode command to
specify the source interface whose IPv4 address will be used as the source IPv4
address for communication with IPv4 SNTP servers. Use the no form of this
command to restore the default configuration.
Syntax
sntp source-interface interface-id
no sntp source-interface
Parameters
• interface-id —Specifies the source interface.
Default Configuration
The source IPv4 address is the IPv4 address defined on the outgoing interface
and belonging to next hop IPv4 subnet.
Command Mode
Global Configuration mode
User Guidelines
If the source interface is the outgoing interface, the interface IP address
belonging to next hop IPv4 subnet is applied.
If the source interface is not the outgoing interface, the minimal IPv4 address
defined on the interface is applied.
If there is no available IPv4 source address, a SYSLOG message is issued when
attempting to communicate with an IPv4 SNTP server.
Example
The following example configures the VLAN 10 as the source interface.
console(config)# sntp source-interface vlan 10