Dell PowerEdge VRTX - Manual (Page 717)

IP Routing Protocol-Independent Commands 717
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\IP_Routing_MeS.fm
D E LL CO N F I D E N T IA L – P R E L I M I N A RY 4 / 3 / 14 - F O R PR O O F O N LY
ip routing
To enable IP routing, use the ip routing command in global configuration
mode. To disable IP routing, use the no form of this command.
Syntax
ip routing
no ip routing
Parameters
This command has no arguments or keywords.
Default Configuration
IP routing is disabled.
Command Mode
Global Configuration mode
User Guidelines
Use the command to enable IP Routing.
The switch supports one IPv4 stack on in-band interfaces and the OOB port.
The IP stack is always running on the OOB port as an IP host regardless
whether IP routing is enabled.
The switch blocks routing between in-band interfaces and the OOB interface.
In the case when there are two best routes - one via an in-band and one via
the OOB port, the switch will use the route via the OOB port.
DHCP Relay and IP Helper cannot be enabled on the OOB port.
Example The following example enables IP routing
console(config)# ip routing